• 100 Quatrex drive screws & washers
• Screws are 10-32 threaded, truss head
• Finish is black oxide, hardened
• Quatrex drive accommodates both Phillips and Robertson bits

HS-L

H-BIT-100

• 50 Torx with pin drive screws & washers
• Screws are 10-32 threaded, button head
• Finish is black oxide, hardened
• Designed to be used where some security is required to keep equipment within a rack
• The special driver bit is available, see H-BIT-100 below.

• A complete large security driver bit set is also available, click this part number H-BIT-100 for more information.

• Use this all metal key lock substitute to replace any of our regular keyed locks.
• This product would be used in locked rooms where

• Cable Hanger
• Can be attached to the side of your rack, or in the workshop to keep your test cables tidy!

RRF-42

CUT

• Threaded Rack Rail, Full Hole (3 per space)
• Threaded 10-32", 1/8" thick CR Steel.
• Painted black powder coat
• Available in 1 length only, 42 rack spaces, 73.5"
• Custom lengths are available, Order the RRF-42, advise how you would like it cut up.....there is a per cut charge per pair for this service(Order Part Number CUT, along with the RRF-42)

RLF

• 3" Casters, two locking, two non locking per set
• Rated at 250 lb. per wheel
• Bolt these to the bottom of the RME rack to turn it into an economical rolling rack.
• Note: these casters are made of a hard plastic, and are not recommended for use on a waxed, polished or easily scratched floor. Use the RW4 or the RWL4 for these types of applications
• It is highly recommended that caster bases are used on all racks over 30 rack spaces.
• Install Hardware included

• 4" Soft Roll Casters, two locking, two non locking per set
• Rated at 125 lb. per wheel
• Bolt these to the bottom of the RME rack to turn it into an economical rolling rack.
• It is highly recommended that caster bases are used on all racks over 30 rack spaces.
• Install Hardware included